Camera Systems Built for Large Industrial Spaces

For large open floor areas, varifocal cameras (typically 2.8–12mm or 4–16mm zoom range) are the right tool — they let us tune the field of view for each specific location rather than being locked into a fixed lens. For loading docks and perimeter, we use cameras with built-in IR and weatherproof housings. For high-ceiling overviews, fisheye cameras can work for general activity awareness but shouldn't be your primary identification tool — they distort too much to get usable detail on individuals.

Tall shelving is the defining challenge in a warehouse install. The approach depends on the layout: for open-aisle warehouses, ceiling-mounted cameras at each aisle end capture people moving in and out of aisles. For tighter racking configurations, we may position cameras at the top of rack bays looking down aisles from a higher mount point. Some situations benefit from supplemental cameras mounted on the racking itself for specific zones — we'll assess your layout and give you an honest view of what can and can't be covered before the install.

Loading docks need two angles: one covering the exterior truck bay area (who pulled in, what vehicle, what time) and one inside the dock door capturing freight movement and the people handling it. The interior dock camera needs to handle the challenging lighting condition of a door that alternates between fully open (bright exterior light) and closed — we use wide dynamic range (WDR) cameras that handle that contrast without blowing out or going dark. Dock cameras are where shrinkage documentation is most critical, so we don't cut corners on the hardware spec here.

Storage requirement depends on camera count, resolution, and frame rate. As a rough benchmark: 16 cameras at 4MP recording 24/7 at moderate compression typically requires 20–30TB for 30-day retention. 32 cameras doubles that. We calculate storage precisely based on your camera spec and compression settings before the NVR is configured — and we build in margin so you're not losing days at the end of the month because the math was tight. RAID configuration adds redundancy so a drive failure doesn't mean a gap in your retention window.

Yes, but standard cameras fail quickly in freezer environments — condensation when doors open and the temperature cycling destroy standard electronics fast. Cold storage requires cameras with operating temperature ratings down to -40°F or lower, heated housings in some cases, and connectors rated for the environment. We've installed in walk-in coolers and blast freezers — it requires the right hardware spec and attention to where cables enter the cold zone to prevent condensation issues. Let us know your temperature range when you reach out and we'll spec appropriately.